R20 ONVIF and Synology Surveillance Station

Entry Level Doorphone
dschille
Posts: 5
Joined: Fri Dec 21, 2018 3:46 am

R20 ONVIF and Synology Surveillance Station

Postby dschille » Mon Jan 07, 2019 12:48 am

Hi,

I am trying to connect the R20 camera with our Synology Surveillance station via ONVIF.
The Surveillance station discovers the R20 camera correctly but fails to connect (and also to get the technical details from the camera).
Tried also simple and even no password settings and port 8090 (mentioned in the manual).

The RTSP stream works fine but I would like to use a password protected access to the stream.

Any ideas/suggestions?

Thanks!

Dirk

Akuvox_Shirley
Posts: 44
Joined: Wed Apr 04, 2018 10:50 am

Re: R20 ONVIF and Synology Surveillance Station

Postby Akuvox_Shirley » Mon Jan 07, 2019 2:10 pm

Hi sir,

You can go to R20's web - Intercom - ONVIF to configure its username and password.
Then if users want to get the ONVIF video stream, they should enter the correct username and password.
Hope it will help you.

Thanks&Best regards.
You do not have the required permissions to view the files attached to this post.

dschille
Posts: 5
Joined: Fri Dec 21, 2018 3:46 am

Re: R20 ONVIF and Synology Surveillance Station

Postby dschille » Mon Jan 07, 2019 4:16 pm

Hi,

thanks for the reply.
Yes I know that I can configure the ONVIF username/password (since I did it).

The problem is, that I cannot access the ONVIF stream with our Synology surveillance station solution (nor via the URL http://IP_address:8090/onvif/device_service given in the manual, of course I substituted <IP_address> with the actual IP address).

Thanks and regards!


Return to “R20”

Who is online

Users browsing this forum: No registered users and 0 guests